Multicolor (RGB) LED with Arduino PWM

Share on facebook
Share on google
Share on twitter
Share on linkedin
A VPN is an essential component of IT security, whether you’re just starting a business or are already up and running. Most business interactions and transactions happen online and VPN

This is the next step from our last post, where we take the single color example of PWM brightness control, and expand it to a RGB LED with a whole spectrum of color outputs. Instead of having one potentiometer, we now have three. Instead of using one analog ports, we use 3, and the same on the pwm ports.

The wiring is similar, each pot connects to +5 and ground on the outside legs, and each center pin connects to a analog port. The RGB LED has 4 legs, one for each color and a common anode. Arduino pins 7,6, and 5 connect to R, G, and B respectively (through a 270 ohm resistor). The code is similar, just duplicated lines for the other two colors.

Now you can make pink, turquoise, and more. The next step will be to upgrade to a 1 watt RGB LED, which requires 3 power transistors to handle the increased current.

(video uploaded to youtube)


3 Linear Taper 5k ohm potentiometers
3 270 ohm resistors
1 RGB common anode LED
1 Arduino

Download .pde

int sensorPinR = A0;    // red pot
int sensorPinG = A1; // green pot
int sensorPinB = A2; // blue pot
int ledPinR = 7; // red LED
int ledPinG = 6; // green LED
int ledPinB = 5; // blue LED
int sensorValueR = 0; // red variable
int sensorValueG = 0; // green variable
int sensorValueB = 0; // blue variable

void setup() {}

void loop() {
  // read the value from the sensor:
  sensorValueR = analogRead(sensorPinR);
    sensorValueG = analogRead(sensorPinG);
      sensorValueB = analogRead(sensorPinB);
  // converts 0-1023 to 0-255
  sensorValueR /=4;  
   sensorValueG /=4;  
    sensorValueB /=4;   
  // outputs PWM signal to LED
  analogWrite(ledPinR, sensorValueR);
    analogWrite(ledPinG, sensorValueG);
      analogWrite(ledPinB, sensorValueB);

Steve Spence

Steve Spence

Leave a Reply

7 thoughts on “Multicolor (RGB) LED with Arduino PWM”

  1. This information helped me out with a project I am working on. I bought a LCD display that had a multi color back light. I used your example here to get it working properly.

    In my project I have a rotary encoder to select the values for ledPin's. I display the value on the screen and use a push button to switch between R-G-B. Thanks again for the info.

  2. I'm curious as to why you chose resistors and not a driver and why you used the same amount of resistance for each lead since each color uses a different amount of power and it's typically stated that you need to use different resistances for each one?

Leave a Comment

Your email address will not be published. Required fields are marked *